Led table lamps – You’ll find a beautiful vintage vase, but it’s too old to risk filling with water. You can easily make it boudoir table lamps. But, led table lamps switches can break from the constant rotation created when you turn the lamp off and on. And rather than throwing out your lamp, replace it by replacing the plug. The contact is actually part of the socket and is a much easier replacement than trying to repair the connector on its own. And you can save your led table lamps, also save money by repairing it instead of replacing it.
How to repair a broken connector on a led table lamps, remove the lampshade and bulb from the lamp. Remove the harp from the lamp by squeezing the sides of the harp against the plug and lifting it up and out of the harp base. Harp is the part of the lamp that holds the shade. Grasp the outer sleeve in the hand and pull up and away from the base. The outer shelf shell may require some less force to pull it up and out. Pull the inner socket switch from base to access socket change wires. When the wires are exposed, use a screwdriver to loosen the screws on each side of the inner base and remove the wires underneath the screws.
12 Photos Gallery of: How to Repair a Broken Connector on Led Table Lamps
Then for repair a broken connector on a led table lamps, install the new interior socket switch. Feel the lamp wires. A lamp wire is ribbed or rough; Wrap this thread around the silver colored screw on the side of the new socket switch. And the remaining wire is smooth and wraps around the copper screw on the opposite side of the socket switch. Tighten both screws to secure the lamp wires securely into place. Slide the outer sleeve back over the inner shelf, push it in place. And then replace bulb harp, bulb and lamp shade.