Pull chain table lamp – Despite the endless variety of styles of lamps and decorative elements, most lamps have very similar electrical components. This means that if a part stops working, you just have to remove it and take it to the hardware store or home center to find a suitable substitute. A traction chain switch is no exception. In most cases, to solve a bad switch by replacing the entire socket, since the switch is usually integrated with the socket. Excluding purchases, all work must be less than 30 minutes. Unplug the lamp and remove the bulb from the socket. Remove the shadow or balloon. If applicable, remove the harp (the metal structure that supports the shadow), squeezing the two ends together and slide out of the brackets on each side of the bushing assembly.
Pull chain table lamp, remove the cylindrical metal housing that surrounds the socket by tightening around the box where it fits into a base part, sockets often have the word “PRESS” sealed in the places where it is best to squeeze into the casing. Pull the cover of the assembly socket. Remove the cardboard insulation cover from the socket to expose the screw terminals that hold the wires of the lamp cable. Loosen the terminals with a screwdriver and disconnect the cables. This should release the socket. If not, look for the screws that hold the base of the mounting base and remove the screws to release the socket.
12 Photos Gallery of: How to Repair Pull Chain Table Lamp
Buy a replacement outlet with a switch that matches the original. The shots may vary slightly in height and appearance, but the diameters must be identical. Connect one of the pull chain table lamp wires to each terminal in the socket, as before. Reassemble the bushing in the reverse order of disassembly. It is usually very good to use the original base, even when the replacement socket includes a base. Reinstall the harp, shadow and bulb. Plug in the lamp and test the new switch.